Husqvarna DM 220 Manual De Usuario página 9

but keeps the motor on for some seconds. The friction
clutch engages again if the load is decreased and the
operation can continue. If the drill bit is caught in the
material and fully stops, the friction clutch stops the
motor immediately.
CAUTION:
time of the clutch is not more than 3-4
seconds, because if not wear and heat will
increase quickly.
PRCD
WARNING:
type sold in United Kingdom and Ireland.
United Kingdom and Ireland: Do not operate
the 110V type of the product without
an isolation transformer, refer to EN/IEC
61558-1 and EN/IEC 61558-2-23. The
isolation transformer must have a grounded
earth wire on the secondary winding side.
WARNING:
water.
WARNING:
product, always do a check of the PRCD.
To examine the PRCD on page
Refer to
9 .
The product has a PRCD installed on the power cord.
The PRCD is for protection and engages if an electrical
Technical data on page 22 for
fault occurs. Refer to
information about at which current the PRCD engages.
The red light shows that the PRCD is on and that the
product can be started. If the red light does not show,
push the RESET button.
To examine the PRCD
WARNING:
type sold in United Kingdom and Ireland.
PRCD on page 9 .
Refer to
1794 - 001 - 24.03.2022
Make sure that the release
Not applicable for 110V
Do not put the PRCD into
Before you operate the
Not applicable for 110V
WARNING:
examined each time the power plug is
connected to a power outlet.
WARNING:
repaired, always speak to an approved
Husqvarna service agent.
1. Connect the power plug of the product to a power
outlet.
2. Push the "RESET" button. The indicator above the
button is red when the current is connected.
3. Start the product, refer to
page 15 .
4. Push the "TEST" button. If the product stops, the
PRCD operates correctly.
Power switch
The power switch is used to start and stop the product.
To do a check of the power switch
1. Connect the power plug of the product to a power
outlet.
The PRCD must be
If the PRCD must be
To start the product on
9