Operation; Cutting Blades; Diamond Blades - Husqvarna FS 600 E Manual De Usuario

Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
CAUTION:
cord longer than maximum 25 m and less
than minimum 2.5 mm
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the instructions that are supplied with the
cutting blade by the cutting blade manufacturer.
• Before each operation of the product, do these
steps:
a) Do the daily maintenance. Refer to
schedule on page 22 .
b) Make line marks for all cuts. Prepare the
operation sequence carefully to prevent injury
and damage.
c) Make sure that the cutting blade and the blade
guard is correctly installed. Refer to
a cutting blade on page 12 and To install the
blade guard on page 14 .
d) Adjust the handle to an applicable operation
position. Refer to
page 12 .
e) Fill the water tank or connect the external water
supply. Refer to
17 and To connect the external water supply on
page 18 .
f) Make sure that the water tube in the blade guard
is open. Each side of the cutting blade must have
sufficient supply of water.
g) Make sure that the pointer is aligned with the
cutting blade. Refer to
the cutting blade on page 16 .
h) Connect the power plug of the product into a
extension cord and then into the mains outlet.
1620 - 003 - 28.02.2022
Read and understand the
Do not use an extension
2
.
Maintenance
To install
To adjust the handle height on
To fill the water tank on page
To align the pointer with

Operation

i) In some conditions you must reverse phases.
Refer to
j) Turn the machine stop button clockwise to make
sure that the button is disengaged.

Cutting blades

WARNING:
for other materials than which it is made for.
WARNING:
for wet cutting. The diamond blade must be
applicable to the same speed or a higher
speed than the value given on the product
type plate. Only use diamond blades that
are in compliance with national or regional
standards, for example EN13236 or ANSI
B7.1.
The cutting blade manufacturer gives warnings and
recommendations for the operation and correct
maintenance of the cutting blade. Those warnings are
supplied with the cutting blade.

Diamond blades

WARNING:
direction of rotation for the diamond blade
shown on the diamond blade aligns with the
direction of rotation shown on the product.
Error indicator on page 25 .
Do not use a cutting blade
Only use diamond blades
Make sure that the
11