V2 CITY4-EVO Manual De Instrucciones página 52

PARAMETER VALUE
Strt
StAn
no
APCh
PrES
oroL
StoP
no
ProS
invE
Foto
APCh
CFCh
Ch
no
Ft.tE
no
Si
DESCRIPTION
Activation inputs (START and START P.)
This menu allows selecting input operation modes (see chapter 5.4)
Standard mode
Start inputs from terminal board are disabled.
Radio inputs operate in standard mode
Open/Close command
Dead man operation
Timer mode
Stop Input
The input STOP is not available
The input STOP stops the gate: pressing the command START the gate
continues the motion
The command STOP stops the gate: at the next START the gate starts
moving in the opposite direction
Photocells Input
This menu allows input to be enabled for the photocells
Input enabled on opening and closure
Photocell active on closure and with gate stopped
Input enabled for the closing phase only
m
WARNING: If the photocell is damaged the gate is opened
anyway.
Before closing the test of the photocell (if enabled) will detect
the fault and prevent the gate from closing.
Input disabled
Test of the photocells
In order to achieve a safer operation for the user, the unit performs a
photocells operational test, before a normal working cycle.
If no operational faults are found, the gate starts moving.
Otherwise, it will stand still and the flashing light will stay onfor 5 sec.
The whole test cycle lasts less than one second
Function deactivated
Function activated
StAn
- 50 -
AntE SCor
MEMO
StAn StAn
no no
CFCh CFCh
no no