Cleaning The Vermiculite Components - klover WAVE 90 Instrucciones De Uso

CS.W110.IST-1 / Rev 1.3
Remove the plate covering the right-hand smoke circuit inspection port
Dismantle the right-hand smoke circuit inspection valve
Remount the two previously removed elements and check the tightness of the underlying seals.
18
In the fireplace insert, suck up the combustion residues deposited inside the smoke pipe connection point
After completing the cleaning phases explained above, the insert should be pushed and reattached, making sure that the seals adhere full to the
To ensure correct operation, it is necessary to remove the sawdust deposited on the base of the tank

Cleaning the vermiculite components

The vermiculite panels do not require any special maintenance. If necessary, they must be dusted gently using a brush only. To avoid jeopardising
their durability, they must not be cleaned using abrasive sponges, wet cloths or the tube of the ash vacuum device placed directly in contact with it.
14
16
stop point. In the fireplace insert, screw on the two front locking knobs.
pellet tank must be emptied at the end of every season.
15
(Fig. 14) and suck up the combustion residues deposited inside
17
(Fig. 16) and suck up the combustion residues deposited inside
19
25
(Fig.
(Figure 18).
(Figure 19) at least once every 30 days. The
ENGLISH
(Fig. 15).
17).