Cleaning The Ceramic Glass; Cleaning The Flue; Maintenance Of The Boiler Body; C.a.t Maintenance - klover BFM-01 Instalación Uso Y Mantenimiento

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Clean any obstructions in the lateral fumes passage and re-mount the inspection outlet.

Cleaning the ceramic glass

Always clean the glass when the stove is off and completely cold. Use a damp cloth and specific detergent for ceramic glasses. Do not use abrasive
sponges.

Cleaning the flue

This operation must be performed at least once a year, at the start and half way through the winter season, and however when necessary.
It is necessary to check the presence of any blockages in the flue before switching the thermo stove on, following a long period of inactivity.
If cleaning is not performed, the functioning of the thermo stove and its components may be jeopardised.
The frequency of cleaning of the thermo stove and the flue depend on the quality of the pellets and wood used.
USE TOP QUALITY PELLETS AND WOOD TO OBTAIN THE BEST RESULTS.

Maintenance of the boiler body

The thermo stove is equipped with a special magnesium anode to protect the boiler body and stainless steel heat exchangers from corrosion due to stray
currents in the system.
This anode protects from galvanic corrosion.
MAGNESIUM ANODE
The anode must be controlled at least once a year and replaced when its diameter measures less than 15mm.
In order to inspect the boiler body, after the lid of the thermo stove majolica has been removed, remove the upper lid fastened and with two knobs.
To replace the anode, just loosen it and screw-in the new one paying attention that the latter does not come into contact with the stainless steel heat
exchangers.

C.A.T Maintenance

Punctual and systematic maintenance is a fundamental component for correct functioning, excellent thermal performance and duration of the appliance
through time. Therefore, it is recommended that qualified staff check the thermo stove at least once a year at the beginning of the season.
It is advised to agree an annual contract for product maintenance with the Authorised After-Sales Centre (C.A.T.).
CIRCUIT BOARD PARAMETERS
THE PARAMETERS MEMORISED ON THE CIRCUIT BOARD ARE FUNDAMENTAL FOR THE CORRECT FUNCTIONING OF THE THERMO STOVE
THE PARAMETERS GIVEN BELOW ARE ALREADY MEMORISED IN THE THERMO STOVE INSPECTION PHASE DIRECTLY IN THE FACTORY.
THESE PARAMETERS ARE THE RESULT OF CAREFUL TESTS WITH VARIOUS TYPES OF PELLETS AND MUST NOT BE CHANGED WITHOUT
THE AUTHORISATION OF KLOVER srl, SO AS NOT TO JEOPARDISE THERMO STOVE FUNCTIONING.
ALL LIABILITY IS DECLINED FOR DAMAGE CAUSED BY INCORRECT INTRODUCTION OF THE PARAMETERS.
24
Tabla de contenido
loading

Tabla de contenido