Cleaning And Maintenance; Precautions Before Cleaning; Routine Cleaning - klover WAVE 90 Instrucciones De Uso

CS.W110.IST-1 / Rev 1.3

CLEANING AND MAINTENANCE

Precautions before cleaning

Before carrying out any cleaning or maintenance operations, make sure that:
- the appliance is off and has cooled down completely;
- the ash is completely cold.
- the ash vacuum device used for cleaning is suitable and its filter is in good condition.
Before re-starting the appliance, re-install all previously removed components.
During cleaning operations, use the personal protection devices specified in Directive 89/391/EEC.
The required cleaning frequency depends on the type and quality of the pellets used. The schedule indicated below may therefore vary.
Any problem affecting the appliance caused by lack of cleaning will not be covered by the warranty. The failure of these operations could
affect the safety of the product.
Cleaning operations may be carried out by the end user, as indicated in the paragraph below.

Routine cleaning

The ordinary cleaning of the appliance must be done at least every 30 hours of operation or after 6–8 ignition cycles, so as to always guarantee
efficient performance and optimal operation. Proceed as illustrated below:
1
3
Use the appropriate cleaning hook for the front scraper to pull out the two front rods and then move them forward and backwards to clean off
Remove the brazier covering ring
Remove the flame separator as shown in the picture
4
combustion residues from the air exchanger
(Fig. 4) and remove the combustion residues from the brazier
2
2
(Fig. 1 and
(Fig. 3).
23
1
2).
5
(Fig. 5).
ENGLISH