Tabla de contenido
SURFACE MOUNT
These instructions are for surface mounting your cabinet, supplied with surface side kit (USMK27D6P)
Note: Two Mounting Bars are supplied with your mounting kit. The chart below outlines the total mounting bar length required
for each cabinet.
Hint: The holes on the Mounting Bars are intentionally left undrilled for easier installation when aligning the Mounting Bars with the
structural supports. Depending on your mounting configuration, one or both mounting bars may need to be cut.
Cabinet Width
48" (1219 mm)
36" (914 mm)
30" (762 mm)
24" (610 mm)
1. Refer to the mounting bar requirements (below) making sure that all requirements are met when installing the mounting bars.
Total length of mounting bar(s) must equal that shown in chart above
At least one screw in each mounting bar MUST be installed in a structural member (stud, etc.)
At least two mounting screws must be used in each mounting bar.
If two mounting bars are used, then both must be aligned and up against one another
Minimum 4 screws must be used when installing a cabinet
2. Locate and drill four 3/16" holes through the indent line on the Mounting Bar, as required to mount the bar, meeting the above
requirements. Screws not mounted in a structural member (stud, etc.) should use the supplied plastic anchors.
© 2019 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
Total Mounting Bar Width
45" (1143 mm)
33" (838 mm)
27" (686 mm)
21" (533 mm)
6
Part no. 209-1318-A rev. 08/21/19
Ganging Kit
Tabla de contenido
