Idiomas disponibles
Idiomas disponibles
Update Firmware
1. Click on
SELECT FILE
This file must be a valid file, with PRZ extension
2. Select the type of network within which the device is installed (Normal / Slow Networks)
Slow networks for low quality / low bandwidth GPRS environments
Normal for normal conditions
3. Click on
SEND FIRMWARE
This button will remain deactivated until a valid file has been selected.
4. Click on
APPLY NEW FIRMWARE
This button will be activated once the file has been uploaded and it has been verified, using md5,
that the file has not been corrupted.
OK
5. Click on
6. Wait for the time indicated on the website before performing any action on the charger
For safety reasons, the charger firmware cannot be updated when the charger is certain states. The following
table (Table 2.13) indicates when this is possible. If it is not possible, a warning message will be displayed
after clicking on Apply new firmware.
#
1
2
3
4
5
6
7
8
9
10
11
12
13
The charger state can be found on the Synoptic and Measures web pages.
3.7 E
XIT
If this option is selected, the user that was connected at that moment will be deauthenticated.
The browser will be redirected to the home page.
3.8 D
ISCONNECTION DUE TO INACTIVITY
If the maximum inactivity time specified by the tact parameter is exceeded, and you then try to consult any
page or perform any action, a message like the one in Figure 2.26 will be shown, and you will be redirected
to the home page once you click on OK.
www.premiumpsu.com
Powering Your Challenge
and select the file that contains the update.
in the warning window that opens.
Table 3.13 - Charger states and updating
CHARGER STATE
STARTING
QUICK CHARGING
FLOATING
NO BATTERY
AC INPUT ERROR
BATTERY TEST
OVERLOAD
OVERLOAD TEST
CHARGER FAILURE
BATTERY ABSENCE TEST
BATTERY CHARGED
FAILURE TO START
RECOVERING BATTERY
Figure 3.26 - Disconnection message
Communications' Operation Manual
ALLOWED TO UPDATE
NO
YES
YES
YES
NO
NO
NO
NO
NO
NO
YES
NO
YES
EPS Series
MA-5192B-1
07-10-2021
/
26
77
Capítulos
