Preparation For Use - Baker Hughes Druck PACE 5000 Guia De Instalacion

Pneumatic Connections
In the event of a power failure or other fault condition the customers system should have other
means for indicating pressure in pressure lines connected to the PACE.
Fit manual vent valves to pressure lines connected to the PACE +ve source input port and output
port to allow safe venting to atmosphere of these pressure lines in event of power failure or other
fault condition.
WARNING
lines before disconnecting or connecting the pressure lines. Proceed with care.
Only use equipment with the correct pressure rating.
Before applying pressure, examine all fittings and equipment for damage.
Replace all damaged fittings and equipment. Do not use any damaged fittings
and equipment.
Do not exceed the maximum working pressure of the instrument.
This equipment is not rated for oxygen use.
Electrical Connections
RISK OF ELECTRIC SHOCK
connected to the AC supply protective safety ground.
Isolate the power supply before making any electrical connections to the rear
panel.
Packaging
INFORMATION
stabilize and any condensation to evaporate.
Check the contents of the PACE5000/6000 packaging with the list that follows:
i. PACE5000 or PACE6000 Pressure Controller.
ii. Cable, power supply.
iii. User guide.
iv. Pneumatic Control Module blanking plate (keep this plate for future use).
CAUTION
flow of cooling air.
After unpacking an instrument that has been in cold conditions allow time to
stabilize and any condensation to evaporate.

1. Preparation for Use

The instrument can be used as a:
• Free-standing instrument positioned on a horizontal surface.
• Rack-mounted in a standard 19 inch rack using the rack-mount option kit (Refer to K0443,
Section 2.8, Rack-mount Option).
For free-standing instruments, the feet on the front of the base can be used elevate the instrument
to a better viewing angle.
Note: Do not obstruct the air cooling outlet on the underside of the instrument and allow a free
flow of air around the instrument, especially at high ambient temperatures.
Key to Figure A1
Copyright 2008 Baker Hughes Company.
2 | PACE5000/6000 Safety Instructions–English
Turn off the source pressure(s) and carefully vent the pressure
After unpacking a cold instrument, allow time for it to
After removing a control module, use a blanking plate to keep the
The ground lead of the instrument must be