Leister VARIANT T1 Instrucciones De Funcionamiento página 12

Converting to Hem Welding
Allow welding nozzle (9) to cool down (see operating instructions
VARIANT T1, page 31, section 1.8).
The device may only be converted while the welding nozzle (9) is cold.
Turn off main switch (3).
230
Disconnect power supply cord (1) from power supply.
400
• Disassembly
– Pull round belt (23).
– Remove pressure roller (11) by loosening the screw (35)
(Fig. A).
– Remove round belt flange (36) by loosening the screw (37)
(Fig. B).
– Remove diverting roller (12) by loosening the screw (41)
(Fig. C and D).
– Remove hold-down device (13) by loosening the star knob
screw (39) (Fig. E).
– Remove guide roller (15) by loosening the screw (40)
(Fig. F).
35
11
(Fig. A)
39
(Fig. E)
• Assembly
– Insert pressure roller (11) and push as far as it will go.
– Fasten pressure roller (11) with screw (35).
– Fasten hold-down device for hem / piping (42) with the
screw of the diverting roller (41) (Fig. G).
– Move in hem / piping add-on part (43) (Fig. H) and
fasten with screw (40).
42
41
(Fig. G)
12
37
(Fig. B)
40
13
(Fig. F)
43
(Fig. H)
41
(Fig. C)
15
9
40
12
41
15
41
(Fig. D)
43
40
3
37
36
35
11
23
13
39
12
35 11
42
41