Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Make sure each snap hook is positioned so that its keeper
(gate) is never load bearing.
NOT for recreational or sporting use.
Snap hooks attached onto D-ring must have less than 3/4"
throat opening. Never attach ladder or rebar hooks onto
harness D-ring.
Only attach connecting devices that meet government
standards to D-rings.
Always attach snap hook to proper anchorage for the
intended use or the proper D-ring of harness.
For fall arrest, use the dorsal D-ring located on center
back of harness.
Never disable locking keeper on hook, punch holes in or
alter a connecting device in any way.
Never join snap hooks together. They are NOT meant to
be used that way, and could twist apart.
Never attach multiple snap hooks onto a D-ring.
Fall-arrest anchorages must support a minimum of
5,000lbs per attached worker and must be independent
of worker support.
When used for fall arrest, OSHA requires that harness
impact force in a fall NOT exceed 1,800lbs. Minimize
connecting-device slack or use a deceleration unit to
limit force.
Rig to avoid contact with structures below in a fall.
When used for fall arrest, free-fall distance must not
exceed 6 feet.
In travel restraint applications, rig restraint so that no free
fall is possible.
For fall arrest, always keep anchorage above the center
back fall arrest D-ring and allow as little slack in the
lanyard as possible. If climbing above the anchorage,
attach to a new anchorage higher up.
Understand and follow all regulations, warnings and safe
work practices pertaining to the job you are performing
and to the equipment or machinery you are using or
working near.
It is imperative that a Qualified Person select fall
protection system components to fit the specific job
requirements. Incorrect component choices can cause
serious injury or death.
Double check the intended function of any Ergodyne
Full Body Harness before using it. Proper fall protection
system applications are identified in this instruction
manual and are printed clearly on the labels included with
each product. Misuse of a full body harness or any other
piece of fall protection equipment can result in serious
injury or death.
Ergodyne strongly recommends that Ergodyne
components NOT be interchanged with other
components made by other manufacturers, because
Ergodyne cannot guarantee that other manufacturers'
components are free of defects in materials or
workmanship.
Do not alter the equipment.
Do not misuse the equipment.
Do not use combinations of components or sub-systems,
or both, which may affect or interfere with the safe
function of each other.
Do not expose the equipment to chemicals, heat, flames
or other environmental conditions which may produce a
harmful effect. Consult the manufacturer in case of doubt.
Do not use the equipment around moving machinery and
electrical hazards.
Do not use the equipment near sharp edges or
abrasive surfaces.
Exposure to light can lead to UV degradation. Store
and transport the equipment in a cool, dry, clean
environment out of direct sunlight.
LABELS
11
Tabla de contenido
