Cleaning & Maintenance; Correct Disposal Of This Product - Jocel JP1I009159 Manual De Instrucciones

CLEANING & MAINTENANCE
1) Disconnect plug and wait until the unit is cooled down completely. Clean after using every time.
2) If the pots/pans are used without being cleaned, discoloration or cooked on stains may be caused.
3) Do not use benzine, thinner, scrubbing brush or polishing powder to clean the induction hob.
4) Wipe using dish washing agent and damp cloth.
5) Use vacuum cleaner to suck up dirt from the air intake and exhaust vent.
6) Never run water over the unit (Water gets inside may cause malfunction).
FAULT ANALYSIS FOR INDUCTION HOB
E0: Check whether there in no pot or the pot is not acceptable
E1: Check whether the Voltage is too low, lower than 88V
E2: Check whether the Voltage is too high, higher than 280V.
E3: Check whether heat sensor is over heat or short circuit.
E4: Check whether heat sensor is open or invalid.
E5: Check whether IGBT is over heat or short circuit.
E6: Check whether IGBT is open or invalid.

CORRECT DISPOSAL OF THIS PRODUCT

This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They can take this product for
environmental safe recycling
.