Delta 36-714 Manual De Instrucciones página 11

All manuals and user guides at all-guides.com
BLADE TILTING AND RAISING
A
HANDWHEELS
B
Place blade tilting handwheel (A) Fig. 7A on shaft (B)
on the left side of the saw cabinet. Make certain slot
(C) in handwheel is engaged with roll pin (D) on the
D
shaft. Place nylon washer (E) Fig. 7B on shaft then
thread locking knob (F) Fig. 7B, on shaft (G) and tighten
securely. Attach blade raising handwheel (H) Fig. 7B in
the same manner.
INSTALLING DRIVE BELT
C
First, lift motor and remove foam packing block from
around motor. While lifting motor (A) Fig. 8, place a 10-
Fig. 7A
12 inch long piece of 2x4, or another similar thickness
of wood, (B) Fig. 8 as shown. This will help prop up the
motor and will make it easier to install the grooved belt,
H
G
E
(C) Fig. 8A. Place grooved belt (C) Fig. 8A in grooved
pulley located behind the motor (shown in Fig. 8B) and
F
the one directly above, located on the opposite end
of the blade arbor. Ensure that the grooves of the belt
completely make contact with the grooves in these
pulleys. Carefully lift motor and remove the block of
wood. The weight of the motor will provide the correct
tension on the belt. The belt (D) Fig. 8D is shown
installed correctly as seen through the open door in the
side of the saw.
B
Fig. 7B
A
C
Fig. 8A
Fig. 8
D
Fig. 8B
Fig. 8D
11