Operating Modes Led Lights; Silence Mode; Return To Default Settings; Turning Off (Stand-By) / Reset Of The Product - Roca IN-WASH INSPIRA A803094001 Manual De Instrucciones

3.4.2 OPERATING MODES LED LIGHTS

There are four operating modes for light in the In-Wash:
Mode 1 Standard:
This is the pre-set mode of the product.
The lights remain switched off while the In-Wash is not in use.
When the cover is lifted, the lights are switched on. They remain switched on while the product is in use and they switch off one minute after they stop
detecting the user.
Mode 2 Standard with night light:
When this mode is activated, the lights of the In-Wash switch on daily for 8 hours and during the remaining 16 hours the In-Wash remains in Standard
mode.
Mode 3 Night light:
When this mode is activated, the lights of the In-Wash switch on daily for 8 hours and they remain switched off for the remaining 16 hours.
Mode 4 Switched off:
Lights always switched off.
The Light mode may be modified by means of the auxiliary side control:
• Press the Dryer button on the auxiliary side control for 3 seconds. A beep will be heard and the lights will blink indicating the mode of the
In-Wash; 1 blink + 1 beep mode 1, 2 blinks + 2 beeps mode 2 and so on.
• Press successively the Dryer button to change the mode 1, 2, 3, 4, 1, 2, 3, 4... until you reach the desired mode. The lights blink 1, 2, 3 or 4
times indicating the selected mode.
• With the selected mode, press the Stop button on the auxiliary side control or the remote control, to memorise the option, or wait one minu-
te and the last selected mode will be registered.

3.4.3 SILENCE MODE

The In-Wash offers the option of silencing the sound it emits when activating the func-
tions and settings.
To silence it, with the auxiliary side control, press the Drying and Stop buttons simulta-
neously for 3 seconds.

3.5 RETURN TO DEFAULT SETTINGS

❚
To return to the default settings press the Stop button on the remote control for 5 seconds.
All previously modified values will be deleted and the In-Wash will have its default settings:
• Medium water and drying temperature.
• Medium pressure.
• Middle position.
• Light mode 1 (standard).
• It will also carry out a product self-calibration test, in which water flows out of the nozzle for 2 minutes.
• Silence mode disconnected.
❚

3.6 TURNING OFF (STAND-BY) / RESET OF THE PRODUCT

To switch off the In-Wash, press the Stop button on the auxiliary side control for 3 seconds.
To reactivate the In-Wash, press the Stop button on the auxiliary side control.
From that moment on the device carries out a power self-calibration for 2 minutes; during this period
of time water flows out of the nozzle.
Do not disconnect the device during this process.
RESET
The reset process consists in a stand-by manoeuvre followed by the activation of the product.
Each time this process is carried out, a power self-calibration will be carried out for 2 minutes.
22
3 s.
5 s.
x2
3 s.