Cleaning & Maintenance - Bionaire BRH6453 Manual De Instrucciones

shut off. When the room temperature drops
below the preset temperature, the heater will
automatically turn on again to maintain the
preset temperature level.
Note: It is normal for the heater to cycle ON
and OFF as it maintains the preset temperature.
To prevent the unit from cycling, you need
to change the thermostat setting. The digital
thermostat has memory; it will remember the
last temperature setting before the heater is
turned off. However, if the heater is unplugged,
the digital thermostat will no longer remember
the previous temperature setting. You will need
to reset the digital thermostat if the heater is
unplugged.
CLEANING/MAINTENANCE
Always unplug the heater before cleaning and
allow the heater to cool down.
1. Clean the unit with a soft cloth moistened
with a mild soap solution.
2. NEVER use abrasive or flammable solvents to
clean the unit.
TROUBLE
• Heater
☛
Manual user reset is
Does Not
activated.
Turn On.
☛
Not plugged in properly.
☛
Electrical outlet does not hold
plug in securely.
☛
Thermostat set too low.
☛
Obstruction causing the
heater not to operate.
☛
Circuit breaker trips.
• Not
☛
Thermostat set too low.
Enough
Heat.
• Heater
☛
The thermostat automatically
Cycles ON
turns the heater on and off
and OFF
to maintain selected comfort
Frequently.
level.
• Remote
☛
Battery low.
Does not
☛
Distance too far.
work.
☛
Control Panel Display dirty.
All manuals and user guides at all-guides.com
TROUBLESHOOTING FOR YOUR HEATER
PROBABLE CAUSE
3. After cleaning, be sure to completely dry the
unit with a cloth or towel.
Tip: Over time, dust may accumulate on the
front grills. This can be removed by wiping the
unit with a damp cloth.
AUTO SAFETY SHUT-OFF
This heater is equipped with a patented,
technologically-advanced safety system that
requires the user to reset the heater if there is
a potential overheat situation. When a potential
overheat temperature is reached, the system
will automatically shut the heater off to indicate
overheat situation. It can only resume operation
when the user resets the unit.
RESET INSTRUCTIONS
If your heater shuts down:
1. Unplug the unit and wait 30 minutes.
2. Plug in and operate normally.
SOLUTION
✔ Follow reset instructions listed in this
manual.
Ensure plug is properly inserted. Make
✔
sure electrical outlet and circuit breaker
are working.
✔ Have outlet replaced by a licensed
electrician.
Press the Up Button to select the highest
✔
temperature setting.
Unplug the heater and remove all
✔
obstructions. Position your heater 91 cm
away from all objects.
Make sure no other high wattage
✔
appliances are operating on the same
circuit and reset breaker if needed.
Press the Up Button to the highest
✔
temperature setting.
To make this occur less frequently press
✔
the Up Button to the highest setting.
✔ Change battery (2 AAA batteries).
Remote works up to 6 m.
✔
Be sure to point remote at control panel
✔
on heater and there are no obstructions.
Make sure display panel is clean.
✔
7