Remote Control; Battery Replacement - Bionaire BRH6453 Manual De Instrucciones

Figure 1
A
B
C
D
E
F
H
A. Front Grill
B. Remote Control
IR Lens
C. Power Light
D. Temperature
Indicator Lights

REMOTE CONTROL

Your heater comes with a remote control,
unpack the remote control from box. This unit
requires 2 AAA batteries, 1.5 V (not included).
Please note this remote control will not work
through walls. Remove battery before discarding
the remote.

Battery Replacement

a) Remove battery cover from remote control.
b) Remove old batteries from the remote
control.
c) Insert two new batteries, pressing them
firmly into their slot.
d) Replace the battery cover.
Note:
1. Replace all batteries of a set at the same
time.
2. Being careful not to bend or damage the
contact spring, clean the battery contacts
and devices' contacts prior to installing the
batteries.
3. Remove the batteries from the equipment
when it is not being used for an extended
period of time.
4. Remove the used batteries promptly.
5. Do not mix old and new batteries. Do not
mix alkaline, standard (carbon-zinc), or
rechargeable batteries.
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
Note: This unit is for FLOOR USE ONLY.
1. Carefully remove your heater from the
2. Make sure the unit is OFF before plugging
3. Avoid overloading your circuit by not using
4. Plug the heater into an electrical outlet. Once
G
5. Press the Power Button (
E. Power Button
F. Up/Down
ENERGY SAVING SETTING
Buttons
Press the Power Button (
G. Casters (4)
Energy Saving ( ) setting. The heater will now
H. Remote Control
cycle between high (2) and low (1) temperatures
to provide heat. A green light will illuminate on
the screen.
SHUT-OFF
To shut off the heater, press the Power Button
(
The Power Light will blink for one minute while
the unit is shutting down.
Note: For the 120V version, the Power Light will
remain illuminated while unit is plugged in. For
the 220V version, the Power Light will remain
illuminated while the switch on the back is on
( | ). You may turn the Power Light off by putting
the switch on the back to off (
the cord.
Your heater is equipped with a digital thermostat
that allows you to set your heater to a precise
comfort level (18 °C- 30 °C) by pressing either
Up (
digital thermostat mode. Press the Up/Down
buttons on the control panel or remote control
to select your desired temperature level. The
higher temperature is selected, the more
temperature indicator lights will illuminate.
When you continuously press the Up button,
all temperature lights will illuminate to indicate
the maximum temperature (30 °C) is selected.
When the preset temperature is reached, the
heater will cool down by blowing cool air for
60 seconds, the power light will flash during
the cool down period, and then the heater will
6
box. Please save the carton for off-season
storage.
the heater into the outlet.
other high wattage appliances in the same
outlet.
plugged in, the Power Light will illuminate. For
the 220 V version, make sure the switch on
the back of the unit is pressed on ( | ).
panel or remote control to start operation.
The heater will start at the high heat setting
(2). Press the power button again to select
the low heat setting (1).
) again until all temperature lights are off.
THERMOSTAT CONTROL
) or Down ( ) button to activate the
) on the control
) to activate the
o
) or unplugging