Dualit DCM2X Manual página 6

Ocultar thumbs Ver también para DCM2X:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

CLEANING - MONTHLY
BEFORE CLEANING, ENSURE THE MACHINE IS SWITCHED OFF, UNPLUGGED
AND ALLOWED TO COOL. USE DUALIT CAPSULES OR ESE PODS TO REDUCE
FREQUENCY OF CLEANING.
9.A
9.B
WIPE BREWHEAD
UNSCREW
Wipe the entire brewhead
Using a screwdriver and
area and ensure it is
hammer, gently tap the
completely free of coffee
screw to dislodge any dried
grounds. Fine coffee grounds
coffee. Then unscrew
can block the showerhead.
anti-clockwise.
9.D
9.E
UNBLOCK FILTER
UNSCREW
Filters often get blocked with
Locate the measuring spoon
prolonged use. To unblock,
onto the steam wand nut.
use the pin supplied and
Unscrew anti-clockwise and
push through the central
remove.
hole on both sides of the
filter to unblock.
9.G
FLUSH THE
9.H
REPLACEMENT
STEAM WAND
STEAM WAND
IMPORTANT NOTICE:
If the steam wand is completely
Turn on your machine. Flush
blocked, it is possible to remove
the steam wand by dispensing
the wand assembly for cleaning.
water or steam to remove any
Visit our service section on
milk residue from inside the
www.dualit.com/support for
steam wand. Risk of scalding.
replacement advise or to
purchase spare parts.
DESCALE REGULARLY
HARD WATER WILL CAUSE LIMESCALE BUILD-UP,
RESULTING IN BLOCKAGES THAT CAUSE PERMANENT
DAMAGE. IMPORTANT NOTICE: PRODUCT FAILURE DUE
TO THE BUILD UP OF LIMESCALE IS NOT COVERED BY
GUARANTEE.
Dualit recommends descaling regularly, in a well-ventilated area to prevent limescale build up in the
machine. See limescale warning for frequency in your area in accordance with the hardness of your water.
It is essential that a compatible descaler is used. The descale process takes approximately 30 minutes.
CAUTION: AVOID CONTACT WITH DESCALING SOLUTION.
STEAM RELEASED DURING DESCALE PROCESS MAY BE HARMFUL.
RISK OF SCALDING AND INJURY.
9.C
CLEAN BREWHEAD
Thoroughly clean the
showerhead and gasket to
remove any coffee grounds.
Use the filter pin to unblock
or rinse in suds.
9.F
CLEAN THE
STEAM WAND
Use the steam pin to remove
dried milk from inside the
steam wand. Use the measuring
spoon to place the nut back
on the steam wand. Screw
clockwise until tight.
9.I
FILTER PAPER
Remember to use filter papers.
These can help to prevent
filter blockages. These are
available from
www.dualit.com/filterpapers
or by calling Dualit customer
service on 01293 652 500
(UK only).
9
FILTER HOLDER &
10.A
10.B
THE DESCALER
NX
Ensure your descaling product
Place the Holder most
is suitable for coffee machines;
frequently used into the
follow descaling product
machine, ensuring it is empty.
instructions carefully. If
If both Holders and Filters are
you are using a water softener,
used frequently, cycle between
them. Do not soak the
ensure water softener is
removed before adding descaler.
holders in descale solution.
Fill Water Tank with the
descaling solution.
Ensure they are rinsed
thoroughly after descaling.
10.D
10.E
WATER TANK
DESCALE
Insert Water Tank. Plug machine
Ensure Steam/Water Selector
in and turn on. Wait until
is set to water.
machine has reached operating
temperature.
Turn dial completely to the right
to dispense half a tank of water
Caution: Keep hands away
through the Steam Wand.
from Steam Wand at all
Risk of chemical inhalation.
times. Risk of scalding.
If no water comes out, allow to
stand for 5 minutes and repeat
above, allowing the pump to run
for up to 1 minute even if no
water dispenses.
Turn dial fully to the left and
allow the remaining descale
solution to dispense from the
Showerhead, not allowing
the tank to run dry. Risk of
chemical inhalation.
Turn dial to 'Off'.
WWW.DUALIT.COM/REGISTER
DON'T FORGET
TO REGISTER
YOUR PRODUCT
OR BY POST
10.C
CONTAINER
HOLDER
®
Place a container with a capacity
of more than 1 litre on the Drip
Tray underneath the Holder.
Caution: Do not remove
the Drip Tray.
Remove Froth Nozzle from
the Steam Wand. Direct Steam
Wand into container.
RINSE TANK
10.F
AND FLUSH
Thoroughly rinse Water Tank
and fill with fresh water.
Repeat steps 10.B-10.E twice
with water only to remove any
traces of descaling solution.
If you are using a water softener,
ensure that it is replaced into
the Water Tank once the
Water Tank is clean. Risk of
chemical ingestion.
10
Tabla de contenido
loading

Este manual también es adecuado para:

84440

Tabla de contenido