KENMORE ELITE 796.2900 Serie Manual De Uso página 32

TROUBLESHOOTING GUIDE
BEFORE CALLING FOR SERVICE (continued)
Problem
Water in the washer drains
slowly or not at all, or the
display shows:
The display shows:
The display shows:
The display shows:
The display shows:
The display shows:
The display shows:
Possible Cause
Drain hose is kinked, pinched, or clogged.
Drain discharge is more than 96 inches
above bottom of washer.
Load is too small.
Load is out of balance.
Control error.
Water level is too high due to a faulty
water valve.
The water level sensor is not working
correctly.
A motor error has occurred.
Clutch error.
Make sure the drain hose is free of clogs,
kinks, etc., and is not pinched behind or under
the washer.
Adjust or repair drain. Maximum drain
height is 96 inches (8 ft.)
Add one or two similar items to help balance the
load.
The washer has an unbalance detection
system. If individual heavy articles are loaded
(bath mat, bath robe, etc.) and the load is too
far out of balance, the washer will attempt to
redistribute the load. If an unbalance is still
detected, the washer will stop and the error
code will display.
Unplug the washer and wait 60 seconds.
Reconnect power and try again. If the error
reappears, call for service.
Close the water faucets, unplug the washer,
and call for service.
Close the water faucets, unplug the washer,
and call for service.
Allow the washer to stand for 30 minutes
and then restart the cycle. If the LE error
code persists, call for service.
Mechanical failure.
Unplug the washer and call for service.
32
Solutions