Error Codes - KENMORE ELITE 796.2900 Serie Manual De Uso

BEFORE CALLING FOR SERVICE (continued)

Error Codes

Problem
The display shows:
The display shows:
The display shows:
Washer fills with water slowly
or not at all, or the display
shows:
NOTE: If an error message is displayed for four minutes, the water in the tub will automatically drain. An alarm will sound
one minute prior to draining and the original error code will continue to be displayed.
Possible Cause
The lid is not closed properly.
Lid lock switch error.
Special Drain Feature.
Water supply faucets are not fully open.
Water line hoses are kinked, pinched, or
crushed.
Water inlet filters are clogged.
Water supply pressure to faucet or house is
too low.
Water supply connected with leak-
limiting hoses.
Make sure that the lid is closed properly
and press the START/PAUSE button.
After starting a cycle, it may take a few
moments before the tub begins to turn or
spin. The washer will not spin unless the lid
is locked.
If the lid is closed and the lid lock error
message is displayed, call for service.
Make sure that the lid is closed properly
and press the START/PAUSE button. The
washer will not operate unless the lid is
locked.
Make sure that nothing is caught under the
lid, including shipping material or clothing.
Make sure that the latch mechanism is fully
retracted.
If the lid is closed and the lid lock error
message is displayed, call for service.
If the washer is paused during a cycle for
more than four minutes, the cycle will be
cancelled and any water remaining in the
tub will be drained. An alarm will sound at
three minutes to warn you that the tub is
about to drain.
Make sure that the water faucets are fully
open.
Make sure the hoses are not kinked or
pinched. Be careful when moving the
washer during cleaning and maintenance.
Clean the inlet filters. See Maintenance in
the Care and Cleaning section on page 24.
Check another faucet in the house to
make sure that household water pressure is
adequate and flow is not restricted. Discon-
nect the inlet hose from the washer and run
a few gallons of water through the hose to
flush the water supply lines. If flow is too
low, contact a plumber to have the water
lines repaired.
Hoses designed to limit leaks can trip
falsely and prevent the washer from filling.
The use of leak limiting hoses is not recom-
mended.
31
TROUBLESHOOTING GUIDE
Solutions