Idiomas disponibles
Idiomas disponibles
Maintenance
2
2
1
3-20
13) Inspection of starter locking cam
1.
2
1
2.
2
1
14) Replacement of Gear Oil
1.
2.
1
3.
4.
a
Perform the F-N-R operation of the gear shift lever and
confirm that the recoil starter is locked at a position other
than neutral position.
Confirm that the throttle stopper 1 is positioned between
the starter locking cam 2 and the clutch stopper plate.
Also confirm the reverse throttle opening limit when
operating the shift lever in reverse.
Tilt outboard motor a little as shown.
Place drain oil pan below oil plug 1, remove lower oil plug
1 and then upper oil plug 2 to drain oil.
Remove lower oil plug first when draining.
Check gear oil for presence of metal particles, change of
color (abnormal if clouded), and viscosity. Check lower
unit internal components if necessary.
Full tilt down outboard motor and then, fill with gear oil
(from oil tube or pump) through lower plug hole 1 until
gear oil starts to leak from upper oil plug hole a without
air bubble.
Gear Oil :
OIL
Hypoid Gear Oil
API:GL-5 SAE:#90
Gear Oil Quantity :
370 cm
3
(12.5 fl.oz)
· Use lower plug hole when filling with gear oil.
Upper hole cannot be used because doing so
will not allow air to escape from gear case.
· Full tilt down outboard motor to fill gear oil
proper quantity.
GB
2st X18E2 2012
Capítulos
Solución de problemas
