Additional Features; Using The Drying Rack - Kenmore 110.6813 410 Serie Manual De Uso Y Cuidado

Changing the Sensing Cycle settings
to increase or decrease drying time
If all your loads on all Automatic Cycles are consistently less dry
or more dry than you would like, you may change the default
settings to increase or decrease the default dryness level.
Your automatic drying settings can be adjusted to adapt to
different installations, environmental conditions, or personal
preference. This change is retained and will affect all of your
Automatic Cycles, not just the current cycle/load. There are
5 drying settings, which are displayed using the time display:
0 Much wetter clothes, 30% less drying time.
Slightly wetter clothes, 15% less drying time.
1
2 Factory preset dryness level.
3 Slightly drier clothes, 15% more drying time.
4 Much drier clothes, 30% more drying time.
To change the drying settings:
NOTE: The settings cannot be changed while the dryer
is running or paused. The dryer must be in standby mode
(power is off) to adjust the default settings.
1. Before starting a cycle, touch and hold DRY LEVEL
for 3 seconds.
2. Touch DRY LEVEL to select the dryness level shown in the
time display: 0, 1, 2, 3, or 4.
3. Touch START/PAUSE to save the new dryness level setting.

ADDITIONAL FEATURES

Using the Drying Rack

To obtain a drying rack for your dryer, order by calling
1-877-944-7566. You will need your model and serial
number and the purchase date. Remove and discard any
packing material before use.
Use the Drying Rack for items that you do not want to tumble
dry, such as sweaters and tennis shoes. When you use the
drying rack, the drum continues to turn, but the rack remains
stationary.
The drying rack is intended for use with the Timed Cycles
only. The drying rack cannot be used with Sensing/Automatic
Cycles.
To use the drying rack:
IMPORTANT: Do not remove the lint screen.
1. Open dryer door.
10
All manuals and user guides at all-guides.com
2. Align the two hooks on the front of the drying rack with the
3. Place wet items on top of the drying rack. Allow space
4. Close the door.
5. Select a Timed Dry/Air Only, or Low Temperature cycle.
6. When the cycle is selected, the Estimated Time Remaining
7. Start the dryer.
NOTE: Check the lint screen and remove any lint accumulated
from items dried on the drying rack after the cycle is finished.
Using the Drying Rack
holes in the dryer door opening and press down fully into
holes. Rest the rear support on the dryer back ledge.
around items for air to circulate. The drying rack does not
move, but the drum will rotate; be sure to leave adequate
clearance between items and the inside of the dryer drum.
Make sure items do not hang over the edges or between
drying rack grille.
Items containing foam, rubber, or plastic must be dried
on a clothesline or by using the Air Only setting.
display shows the default time. You can change the actual
time in the cycle by increasing or decreasing the cycle time.
(cont.)