Additional Features; Using The Drying Rack; Important; Changing The Drum Light - Kenmore 68102 Manual De Uso Y Cuidado

USING THE DRYING RACK

To obtain a drying rack for your dryer, follow the instructions
included in your dryer drum. Remove and discard any
packing material before use.
Use the Drying Rack for items that you do not want to tumble
dry, such as sweaters and tennis shoes. When you use the
drying rack, the drum continues to turn, but the rack remains
stationary.
The drying rack is intended for use with the Timed Dry Cycles
only. The drying rack cannot be used with any Auto Dry
Cycles.
To use the drying rack:
IMPORTANT: Do not remove the lint screen.
1. Open dryer door.
2. Align the two hooks on the front of the drying rack with
the holes in the dryer door opening and press down fully
into holes. Rest the rear support on the dryer back ledge.
3. Place wet items on top of the drying rack. Allow space
around items for air to circulate. The drying rack does not
move, but the drum will rotate; be sure to leave adequate
clearance between items and the inside
of the dryer drum. Make sure items do not hang over
the edges or between drying rack grille.
4. Close the door.
5. Select Timed Dry. Select the Air Only or Low Temp setting.
Items containing foam, rubber, or plastic must be dried on
a clothesline or by using the Air Only Temp setting.
6. When the cycle is selected, the Estimated Time Remaining
display shows the default time. You can change the actual
time in the cycle by increasing or decreasing the cycle
time.
7. Press START/PAUSE.
NOTE: Check the lint screen and remove any lint
accumulated from items dried on the drying rack after the
cycle is finished.
10

ADDITIONAL FEATURES

Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.

Changing the drum light

1. Unplug dryer or disconnect power.
2. Open the dryer door. Locate the light bulb cover on the
3. Turn bulb counterclockwise. Replace the bulb with a
4. Plug into a grounded outlet or reconnect power.
WARNING
Electrical Shock Hazard
back wall of the dryer. Using a Phillips-head screwdriver,
remove the screw located in the lower right-hand corner
of the cover. Remove the cover.
10-watt appliance bulb only. Replace the cover and
secure with the screw.