Becken BDW1965N IX Manual De Instalación página 32

Turning on the appliance
Starting a washing programme...
Pull out the lower and upper racks, load them with dishes and proceed
accordingly:
1. Push them back. It is recommended to load the lower rack first, then
the upper one (refer to section "Loading the Dishwasher"). Pour in the
detergent (refer to section "D. Detergent").
2. Insert the plug into the socket. The power supply is 220-240 V AC
50 Hz, the specification of the socket is 12 A 250 VAC, 50 Hz.
Make sure the water supply is turned on to full pressure. Open the
door, press the ON/OFF button, press the "programme" button to
select a desired "Washing programme" (refer to section "Washing
programme Table").
Apply a little force to ensure the door is properly closed.
Note: a click will be heard when the door is properly closed.
When the washing is over, you can switch off the appliance by pressing
the ON/OFF button.
Cancel/Change the program
Note: a cycle that is underway can only be modified if it has only been
running for a short time. Otherwise, the detergent may have already
been released, and the appliance may have already drained the wash
water. Should this be the case, the detergent dispenser must be refilled
(refer to section "Fill in the Detergent").
Open the door and press the power button for more than 3 seconds
to turn off the machine and cancel the program. When you restart the
machine, you can change the program to the desired cycle setting
(refer to section "Starting a washing programme").
Note: if you open the door during a washing programme, the machine
pauses, a warning alarm will ring and the display will show E1. When
you close the door, the dishwasher will resume working.
32