Product Usage - Becken BDW1965N IX Manual De Instalación

2.2. Product usage

Installation
If the appliance must be moved at any time, keep it in an upright
position; if absolutely necessary, it may be tilted onto its back.
Positioning and levelling
1. Remove all appliance packaging and check that it has not been
damaged during transportation. If it has been damaged, contact the
retailer and do not proceed with the installation process.
2. Check the dishwasher by placing it so that its sides or back panel
are in contact with the adjacent cabinets or even with the wall. This
appliance can also be recessed under a single worktop.
3. Position the dishwasher on a levelled, sturdy floor. If the floor is
uneven, the front feet of the appliance may be adjusted until it reaches
a horizontal position (the angle of inclination must not exceed 2
degrees). If the appliance is levelled correctly, it will be more stable
and much less likely to move or cause vibrations and noise while it is
operation.
Connecting the water and electricity supplies
Connection to the water and electricity supplies should only be
performed by a qualified technician.
The dishwasher should not stand on top of the water hoses or the
electricity supply cable.
The appliance is to be connected to the water mains using new
hose sets and the old hose-sets should not be reused.
Connecting the water inlet hose
Connect the cold water supply hose to
a threaded ¾ (inch) connector and
make sure that it is fastened tightly in
place.
If the water pipes are new or have not
been used for an extended
Dishwasher | Lavavajillas | Máquina de Lavar Loiça
EN
11