YATO YT-82015 Manual Original página 18

GB
Recommendations for working with the wall chaser
Always wear hearing protectors and dust masks when working. Wear other personal protective equipment such as eye protection,
protective gloves and appropriate work clothing that are capable of stopping small particles generated during work that may be
thrown towards the operator.
Do not cut asbestos or materials containing asbestos. Dust from cutting asbestos is carcinogenic.
Before starting cutting, the fl oor should be checked for other materials than ceramic, especially metal, such as nails, pipes, electric
cables, etc.
Always hold the wall chaser with both hands, using the power tool handles. Holding the tool in the wrong way can lead to a loss
of control over it and increases the risk of injury.
It is forbidden to use the wall chaser without all undamaged and correctly attached guards.
Before each cutting, check the condition of the discs and guards. If any cracks, bends, defects or other damage are detected,
replace the discs or guards with new ones that are free of damage before starting work.
Additional notes
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is used.
Caution! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of use
(including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be specifi ed.
MAINTENANCE AND OVERHAUL
ATTENTION! Before any adjustment, technical service or maintenance operations unplug the tool. Once the operations have been
fi nished, the technical conditions of the tool must be assessed by means of external evaluation and inspection of the following
elements: body and handle, conductor with a plug and defl ection, functioning of the electric switch, patency of ventilation slots,
sparking of brushes, noise level of functioning of bearings and gears, start-up and smoothness of operation. During the guarantee
period, the user cannot dismantle the electric tools or change any sub-assemblies or elements, since it will cancel any guarantee
rights. All irregularities detected at overhaul or during functioning of the tools are a signal to have the tool repaired at a service
shop. Once the functioning has been concluded, the casing, ventilation slots, switches, additional handle and protections must be
cleansed with a stream of air (at a pressure not exceeding 0.3 MPa), with a brush or a cloth without any chemical substances or
cleaning liquids. Tools and handles must be cleansed with a clean cloth.
O R I G I N A L I N S T R U C T I O N S
18