Preparation For Use - GGP ITALY TR 25J Manual De Instrucciones

28
EN

PREPARATION FOR USE

In order to use the edge trimmer, clothes must
be worn that protect against objects thrown up
by the tool (e.g. stones). Wear safety shoes with
a slip-proof sole, gloves, safety goggles (the
visor used on its own does not protect the eyes
sufficiently), tight-fitting clothes. Do not wear
loose-fitting clothes, scarves, ties, jewellery or
other dangling objects that could get caught on
branches. Long hair must be tied up and pro-
tected. Equipment to protect hearing such as ear
defenders must be worn.
INSPECTING THE EDGE TRIMMER
Check that all screws are fastened tightly and
that the mechanical parts are sufficiently lubri-
cated. Check that the air filter is clean. Dirty air
filters may jeopardise performance.
FUEL
This saw has a two-stroke engine. Therefore, fuel
composed of petrol and lubricating oil for 2-
stroke engines must be used.
IMPORTANT
and lubricants to maintain engine performance
and maximize the life of mechanical parts.
IMPORTANT
the brush cutter. This would cause permanent
damage to the engine and invalidate the product
Warranty. NEVER USE fuels that have been
mixed for more than 60 days.
Some conventional petrols are mixed with oxy-
genating agents such as alcohol, ether com-
pounds, or other products suitable to reduce air
pollution. Your engine has been designed to run
with any petrol for motor propulsion, including
oxygenated petrols.
Use unleaded fuel.
ENGINE OIL
Only use top quality synthetic oil for 2-stroke
engines.
Your dealer stocks high quality oils specifically
designed to guarantee a high level of protection
to mechanical parts and maximize engine effi-
ciency.
Contact your local dealer.
Only use high quality fuels
NEVER USE petrol alone in
FUEL COMPOSITION
USE A FUEL COMPOSED OF PETROL AND
SPECIFIC HIGH QUALITY SYNTHETIC OIL
FOR 2-STROKE ENGINES IN A PERCENTAGE
OF 2%
PETROL-TO-OIL RATIO 50:1 = 2% oil.
IMPORTANT
engines is not available to prepare the fuel and
you use a mineral oil specific for lubricating 2-
stroke engines a fuel with 4% oil must be pre-
pared.
PETROL-TO-OIL RATIO 25:1 = 4% oil.
DANGER!
!
Store fuel in appropriate containers in safe
places far from sources of heat or naked
flames. Keep the container out of children's
reach.
MIXING THE FUEL
Add oil to a container suitable to contain petrol
and oil, then add the petrol. Shake the container
to mix well.
Fuel is subject to ageing. This means that it
gradually loses its specifications. Do not prepare
large amounts of fuel, but supplies to last about
one month. Always use excellent quality fuel with
high performance levels.
Before filling, shake the can well to help to mix
the oil and petrol.
WARNING!
!
that forms inside the container.
PREPARATION FOR USE
(SYNTETIC OIL 2T)
If synthetic oil for 2-stroke
Flammable liquid!
Take care over pressure