Adjusting The Tripod - Parkside PKLLP 360 B2 Instrucciones De Utilización Y De Seguridad

˜ Adjusting the tripod
(Fig . C)
NOTE: You can use the dragonfly
alignment of the tripod .
1 . Pull the tripod legs
2 . Lock the tripod legs
Setting the height, tripod feet
1 . Open the snap fasteners
2 . Extend the tripod legs
3 . Close the snap fasteners
Setting the height, crank handle
1 . Fold up the crank handle
2 . Hold the crank handle
3 . Unscrew the locking ring
4 . Crank the tripod to the desired height .
5 . Turn the locking ring
Adjusting the inclination, forward/back
1 . Turn the handwheel bolt
2 . Set the desired inclination .
3 . Turn the handwheel bolt
place .
Adjusting the inclination, sideways
1 . Turn the butterfly screw
2 . Fold the tripod to the desired inclination .
3 . Turn the butterfly screw
Rotating the tripod
1 . Turn the adjusting screw
2 . Hold the handwheel bolt
direction .
3 . Turn the adjusting screw
28 GB/IE
[ 13 ]
apart .
[ 7 ]
into position with the locking ring
[ 7 ]
.
8 ] [
to the desired length .
7 ] [
.
[ 8 ]
.
[ 10 ]
firmly with one hand .
10 ] [
by turning it to the left .
11 ] [
to the right to lock this position .
11 ] [
to the left to loosen .
5 ] [
to the right to lock the inclination into
[ 5 ]
to the left to loosen .
4 ] [
to the right to lock into place .
4 ] [
to the left to loosen .
12 ] [
and turn the tripod in the desired
[ 5 ]
to the right to lock into place .
[ 12 ]
to check the horizontal
.
9 ] [