Initial Use; Inserting / Changing Batteries; Switching On / Off - Parkside PKLL 7 D3 Instrucciones De Utilización Y De Seguridad

Initial use

Check that the delivery is complete and that there is no visible
damage.
Remove the packaging material from the product.

Inserting / Changing batteries

Open the battery compartment cover as shown in the
3a
fig A1.
Insert batteries into the battery compartment as shown in
3
the fig A2.
Make sure that the batteries are inserted in a correct polarity
as shown in the fig A2 before closing back the battery com-
partment cover .
3a
Note: when the battery is low, the LED indicator
blinks.
2
Always replace all batteries at the same time. Only use batteries
from the same manufacturer and with the same capacity.
Remove the batteries from the product if it will not be in use
for a prolonged period of time. In long periods of storage the
batteries can corrode and can run themselves down.

Switching on / off

To switch the product on, push the LOCK switch to the
4
position while the product is on a flat and horizontal surface
(< 4 °). Immediately after being switched on, the product
releases two laser lines from the laser beam opening .
6
32 GB/IE