AZOL GAS MINI Serie Manual De Instrucciones página 23

Resortes de gas
Tabla de contenido
www.azolgas.com
1
Gas springs must be firmly fastened at all the time,
special attention is required when installed into a bored
pocket (groove).
3
A flat surface supporting the whole gas spring base is
required, but in the mentioned side-loads application
the base is not fully supported all the time in the whole
base surface.
5
SOLUTION
1
If detected gas spring is not firmly and properly fitted, a guide bushing should be used to prevent not desired
movements of gas spring during press working operations.
Service in Motion
MOUNTING GUIDELINES
!
!
Groove
2
2
INCIDENT
If significant side-load push gas spring against one
side of the groove, the gas springs are constantly
moving inside the groove on every press cycle.
Marks of impacts are shown on gas springs bodies.
4
Gas spring base is only supported on a partial surface
in contact with the die.
Finally premature wearing or damages on gas spring
reduce its life expectancy.
3
Tel. +34 945290010
XXIII
Tabla de contenido
loading

Tabla de contenido