Pc Input Terminals Connection - Yamaha PDM-1 Instrucciones De Operación

Connections

PC Input Terminals connection

COMPUTER
Installing the ferrite core (Small size)
1
Pull back the tabs
(in two places)
Installing the ferrite core (Large size)
1
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.6 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200
lines.)
(2) The display resolution is a maximum 1,024 × 768 dots when the aspect mode is set to "4:3", and 1,366 × 768 dots
when the aspect mode is set to "16:9". If the display resolution exceeds these maximums, it may not be possible to
show fine detail with sufficient clarity.
(3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible,
you will need to make setting changes to the computer at the time of connection.
(4) Some PC models cannot be connected to the set.
(5) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(6) The computer shown in the illustration is for example purposes only.
(7) Additional equipment and cables shown are not supplied with this set.
(8) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
10
Conversion adapter
(if necessary)
Connect a cable which matches
the audio output terminal on the computer.
2
2
Pull back the tabs
(in two places)
POWER / INPUT — VOL +
R - STANDBY
G POWER ON
Less than
15
3" /
16
(10 cm)
Ferrite core (small size)
(supplied)
Audio
3
Open
3
Open
Ferrite core (large size)
(supplied)
D-sub 15p
RGB
PC cable
Less than
15
3" /
16
(10 cm)
1/8" (3 mm) Stereo plug
Press the cable
through and close
Press the cable
through and close
AUDIO
PC IN