Switching The Flash Unit On And Off; The Selection Menu - Metz mecablitz 64 AF-1 digital Manual De Instrucciones

3.3 Switching the flash unit on and off

• Switch on the flash unit with the
The
MB 64AF-1
mode. To switch off the flash unit, press
digital
the
NIK
If the flash unit will not be used for an
V 1.2
extended period of time, we recommend that
you switch off the flash unit with the
button and remove the power source (dispo-
sable/rechargeable batteries).

3.4 The selection menu

• Press the
The selection menu is divided into 4 sensor
k
buttons:
MODE The modes of operation can be set after
pressing the
O
i-TTL*, chap. 7.1
MODE
i-TTL BL* , chap. 7.2
TTL
A, chap. 7.6
A
M, chap. 7.3
M
GN, chap. 7.5
GN
STROBO, chap. 7.7
STROBO
REMOTE MASTER, chap. 10.1
REMOTE SLAVE, chap. 10.2
REMOTE MASTER
SERVO, chap. 10.4
REMOTE SLAVE
*) only after data exchange with a camera.
SERVO
170
button. The start screen appears. The flash
unit always switches on afterwards with the
mode of operation that was used last (e.g.
manual flash mode M).
D
button flashes red in stand-by
button until all displays turn off.
D
button as often as it takes
for the selection menu to appear.
MODE
button.
The flash parameters can be set after
PARAMETER
pressing the
PARAMETER O
P (partial light output), chap.. 7.3; 10.1.3.1
P / EV
and 10.4.3
EV (exposure correction), chap. 10.1.2.1,
ZOOM
10.1.3.1
N
ZOOM (reflector setting), chap. 9.1
f (Hz)
N (Strobe number of flashes), chap. 7.7
GN
f (Strobe flash frequency), chap. 7.7
GN (Distance guideline), chap. 7.5
F
F (aperture)
ISO
ISO (light sensitivity)
CHANNEL
CHANNEL (Channel), chap. 10.2.2
GROUP
GROUP (slave group), chap. 10.2.3.
The displayed flash parameters are depen-
dent on the selected flash mode.
SERVICE
SERVICE O
The touch display can be configured after
pressing the
BRIGHTNESS
can be reset to the factory setting.
BRIGHTNESS chap. 15.1
ROTATION
ROTATION chap. 15.2
RESET RESET, chap. 16.3
PARAMETER
button.
SERVICE
button, or the flash unit