Teac A-R650mkII Manual Del Usuario página 11

Select a source by turning the INPUT SELECTOR (or
4
pressing one of the input buttons on the remote control
unit).
Tape Monitor Function
If you want to select the source connected to the TAPE 2 jacks,
press the TAPE 2 MONITOR button to turn the tape monitor
function on. The TAPE 2 MONITOR indicator lights.
Press the TAPE MONITOR button again to cancel the tape
monitor function.
< When the tape monitor function is on, sources other than TAPE 2
cannot be heard. Be sure to turn the function off while listening
to other sources.
Play the source, and gradually turn up the volume to the
5
required level by turning the VOLUME knob.
Recording
You can record the sound from the source shown by the lit input
indicator using a recording device connected to TAPE 1/CD or TAPE 2.
1. Select a source to be recorded by turning the INPUT
SELECTOR.
2. Start playback on the source device to be recorded.
3. Start recording.
< The following controls have no effect on the recorded sig-
nal: VOLUME, BALANCE, BASS and TREBLE knobs, MUTE and
LOUDNESS buttons.
< By turning the TAPE 2 MONITOR button on, you can listen to the
sound as it is being recorded by the device connected to TAPE 2.
< This unit cannot dub from TAPE 2 to TAPE 1/CD.
Selecting the speakers
Use the SPEAKERS A and B buttons to turn the speakers on and
off.
When the A button is down:
Sound is output from speakers connected to the SPEAKERS A
terminals.
When the B button is down:
Sound is output from speakers connected to the SPEAKERS B
terminals.
When both the A and B buttons are down:
Sound is output from speakers connected to the terminals of
both SPEAKERS A and B.
When neither A or B button is down:
No sound is output from the speakers. Use this setting when
listening through headphones.
11