Code Identification - Hama Big Zapper Instrucciones De Uso

5.3.4 Press the CH+/CH- keys or POWER to start
the Auto Code Search. The LED indicator
flashes once followed by permanent light.
The Universal Remote Control has a latency of
6 seconds before the first scan starts.
Note: Scan Speed Settings
► Scan Speed Settings can be set at either 1 or
3 seconds. The default setting for the scan
time per single code is 1 sec. If this feels un-
comfortable , you can switch to 3 sec. scan
time per single code. To switch between the
scan times, press CH+ or CH- during the
6 sec. latency before Auto Code Search starts
scanning.
5.3.5 The LED indicator confirms each single code
scan with a single flash.
5.3.6 Press MUTE to save the code and exit the
code search. The LED indicator turns off.
5.3.7 To stop the Auto Code Search during the scan
process, press the EXIT key.
Note
► When all codes are searched without suc-
cess, the Universal Remote Control exits
Auto Code Search and returns to operational
mode automatically. Currently stored code
is not changed.

5.4 Code Identification

The Code identification offers you the possibility, to
determine an already entered code.
5.4.1 Press the SETUP key until the LED indicator is
permanently lit.
5.4.2 Select the device you want to control using
the device key (e.g. TV). A successful selection
is indicated by the LED with one flash follo-
wed by permanent light.
5.4.3 Press SETUP key. The LED indicator flashes
once followed by permanent light.
4
5.4.4 To find the first digit, press the numeric keys
from 0 to 9. The LED indicator flashes once
to indicate the first digit of the 4-digit code
number.
5.4.5 Repeat step 5.4.4 for the second, third and
fourth digit.
TV
6. Special Functions
6.1 Punch Through Channel
The Punch Through Channel allows the CH+ or
CH- commands to bypass the currently controlled
device and switch the channels on a second device.
All other commands remain uninfluenced.
To activate the punch through channel setting:
• Press desired device mode key (e.g. TV).
• Press and hold "CH+" key.
• Press desired device mode key (e.g. SAT).
• Release "CH+" (the indicator flashes once if the
setting is activated).
To deactivate the punch through channel setting:
• Press desired device mode key (e.g. TV).
• Press and hold "CH-" key.
• Press desired device mode key (e.g. SAT).
• Release "CH-" (the indicator is flashing twice if
the setting is deactivated).
6.2 Punch Through Volume
The Punch Through Volume allows the VOL+ or
VOL- commands to bypass the currently controlled
device and adjust the volume on a second device.
All other commands remain uninfluenced.
To activate the punch through volume setting:
• Press desired device mode key (e.g. TV).
• Press and hold "VOL+" key.
• Press desired device mode key (e.g. SAT).
• Release "VOL+" (the indicator flashes once if
the setting is activated).
CODES
SAT