Warranty - T.I.P. Clean Jet 800 Plus + Kit Instrucciones Para El Manejo

MALFUNCTION
1.
The pump is not 1. No current.
discharging any
liquid, the motor is
not running.
2. Thermal motor protection feature has
triggered.
3. The capacitor is defective.
4. The motor shaft is jamming.
2. The motor is 1. The pump housing is not filled with liquid.
running, but the
pump is not 2. Air penetrates into the intake line.
discharging any
liquid.
3. Suction height and/or discharge height
too great.
3. The pump stops 1. The electrical supply does not
after a short time correspond to the information given on
of operation the type plate.
because the
thermal motor
protection feature 2. Pump or intake line are blocked by
has triggered. solids.
3. Liquid is too viscous.
4. Temperature of liquid or environment is
too high.
4. The pump does 1. Refer to section 2.2.
not reach the 2. Worn pump wheel.
desired pressure.

10. Warranty

The present device was manufactured and inspected according to the latest methods. The seller warrants for
faultless material and workmanship in accordance with the legal regulations of the country in which the device
was purchased. The warranty period begins with the day of the purchase and is subject to the provisions below:
Within the period of warranty, all defects which are to be attributable to defective materials or manufacturing will
be eliminated free of charge. Any complaints are to be reported immediately upon their detection.
The warranty claim becomes void in the case of interventions undertaken by the purchaser or by third parties.
Damage resulting from improper handling or operation, incorrect setting-up or storage, inappropriate connection
or installation or Acts of God or other external influences are excluded from warranty.
Parts being subject to wear and tear, such as the pump wheel (impeller) and mechanical shaft seals are excluded
from warranty.
All parts were manufactured using maximum care and high-quality materials and are designed for a long lifecycle.
It should be understood, however, that the wear and tear depends on the kind of use, the intensity of use and the
internals of maintenance. Complying with the installation and maintenance information contained in the present
operating instructions will therefore considerably contribute to a long lifecycle of these wearing parts.
In case of complaints, we reserve the option of repairing or replacing the defective parts or replace the entire
device. Replaced parts will pass into our property.
POSSIBLE CAUSE
6
ELIMINATION
1. Please use a device complying with GS
(German technical supervisory authority)
to check for the presence of voltage
(safety information to be observed!).
Please verify the correct position of the
plug.
2. Separate the pump from the electrical
mains, allow the system to cool down,
eliminate cause.
3. Please contact the customer service
department.
4. Check the cause, eliminate the reason for
the jamming of the pump.
1. Fill the pump housing with liquid (please
refer to "Putting into operation" section).
2. Check to make sure that:
a) the connection points of the intake line are
tight;
b) the inlet opening of the intake line
including the check valve (non-return
valve) are immersed into the liquids being
discharged;
c) the check valve (non-return valve) with the
filter is tight and not jammed;
d) no siphons (i.e. permanently liquid-filled
loops), kinks, counter-slopes or narrow
spots are present along the intake lines.
3. Change the arrangement of the installation
so that the suction height and/or discharge
height will not exceed the max. value.
1. Please use a device complying with GS
(German technical supervisory authority)
to check the voltage of the lines of the
connection cord (safety information to be
observed!).
2. Remove possible congestion.
3. Pump may not be suitable for this liquid. If
feasible, the liquid should be thinned.
4. Make sure that the temperature of the
liquid being pumped and the environment
do not exceed the max. admissible values.
1. Refer to section 2.2.
2. Please contact the customer service
department.
14