Stihl RE 90.0 Manual De Instrucciones página 55

7 Connecting to a water source
So that the water can be drawn in, the height difference
between the high-pressure washer and the water source
must not exceed the max. suction lift (a), @ 18.1.
The appropriate STIHL suction set must be used. The
suction set includes a water hose with a special coupling.
Depending on the market, the appropriate STIHL suction set
may be included with the high-pressure washer.
Connecting the water filter
If the high-pressure washer is operated with water
containing sand from water butts, cisterns or from flowing or
still rivers and lakes, a water filter must be connected to the
high-pressure washer.
Depending on the market, the water filter may be included
with the high-pressure washer.
2
1
3
► Unscrew the connector (1).
0458-002-8721-A
a
► Insert water intake screen (2) into the coupling of the
water hose (3).
Connecting the water hose
3
2
1
► Fill the water hose (1) with water so that no air is present
in the water hose any more.
► Screw the coupling (2) onto the connector of the pressure
washer (3) and tighten by hand.
► Attach the suction cup (4) to the water source so that the
suction cup (4) does not touch the ground.
► If the spray gun is fitted to the high-pressure hose:
Remove the spray gun.
► Hold the high-pressure hose downwards.
► Switch on the high-pressure washer until an even water jet
flows out of the high-pressure hose.
NOTICE
If the high-pressure washer does not suck in water, the
pump may run dry and the high-pressure washer may be
damaged.
► If no water escapes from the high-pressure hose after two
minutes: Switch off the high-pressure washer and check
the water supply.
► Switch off the high-pressure washer.
► Connect the spray gun to the high-pressure hose.
► Press and hold down the spray gun trigger.
► Switch on high-pressure washer.
English
1
4
53