Husqvarna TS 148XK Manual Del Usuario página 27

3/4"
4. Install the anti-scalp roller, the bolt, the washer,
and the nut in the correct position.
5. Adjust all anti-scalp rollers and install them in the
same procedure.
Engine
To lubricate the engine
Only use high quality detergent oil rated with API
service classification SJ-SN. The oil's SAE viscosity
grade refers to the correct temperature for operation.
5W-30
-20 0 30
F
C -20
-30 -10
Note: Multi-viscosity oils (5W30, 10W30, and so on)
help the engine start easily in cold weather but
causes increased oil use when used in temperatures
above 32°F/0°C. Do a check of your engine oil level
frequently to prevent possible engine damage
caused by low oil level.
• Change the oil after intervals of 50 hours of
operation. If the product is not used for 50 hours
in a year, change the oil at a minimum of 1 time a
year.
• Do a check of the crankcase oil level before you
start the engine and after each eight (8) hours of
operation.
• Tighten the oil fill cap/dipstick each time you do a
check of the oil level.
To do a check of the engine oil level
The engine in the product is filled with engine oil for
ambient temperatures of more than 32° F (0° C). For
operation in ambient temperatures of less than 32° F
(0° C), use the correct engine oil to make the product
easier to start. Refer to
1. Park the product in level ground.
2. Remove the oil fill cap and dipstick and clean it
with a cloth.
3. Put the dipstick into the oil fill tube. Do not turn
the oil fill cap onto the oil fill tube.
1717 - 001 - 10.09.2021
9/16"
SAE 30
32 40
60 80
0 10
20 30
. .
4. Remove the dipstick. Use the gauge on the
dipstick to examine the engine oil level. If
necessary, fill engine oil until the mark "FULL" on
the dipstick is reached. Do not fill too much
engine oil.
5. Put the dipstick into the oil fill tube. Make sure
that the oil fill cap is fully tightened.
Note: To replace the engine oil, Refer to
the engine oil on page 27 .
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the
engine oil warm and faster to drain.
WARNING: Do not operate the engine
for more than 1–2 minutes before you
drain the engine oil. The engine oil
becomes very hot and can cause burn
injuries. Let the engine become cool
before you drain the engine oil.
WARNING: Use protective gloves. If you
spill engine oil on your body, clean with
soap and water.
1. Put the product on a level surface and stop the
100
product. Refer to
40
14 .
2. Remove all dirt around the oil tank cap.
3. Remove the oil tank cap and dipstick.
4. Remove the yellow cap (A) from the oil drain
valve (B).
5. Install the oil drain tube (C) to the oil drain valve.
6. Put a container below the engine to collect the
engine oil and put the other end of the oil drain
tube into the container.
7. Push in and turn the oil drain valve
counterclockwise to unlock it.
8. Pull out on the drain valve to open it.
To stop the product on page
B
A
To replace
C
27