Husqvarna TS 148XK Manual Del Usuario página 14

To set the cutting height
• Pull the lift lever in the direction of the seat and
put it in 1 of the notches for the correct cutting
height.
To move forward and rearward
The direction and speed of movement is controlled
by the forward and reverse drive pedals.
1. Start the engine.
2. Disengage the parking brake. Refer to
engage and disengage the parking brake on
page 14 .
3. To start movement, slowly push down on the
forward drive pedal (A) or the reverse drive pedal
(B).
Note: The forward and reverse drive pedals go
back to neutral position when they are not
pushed down.
4. Push down more on the forward drive pedal or
the reverse drive pedal to increase the speed.
To engage and disengage the
parking brake
1. To engage the parking brake, push down the
brake pedal (A) fully to the lowest position.
14
A
2. With the brake pedal pushed down, pull up the
parking brake lever (B).
3. Release the brake pedal.
4. Release the parking brake lever.
Note: Make sure that the parking brake holds the
product safely.
5. To release the parking brake, push down the
brake pedal.
To stop the product
To
A
1. Push down on the brake pedal (A) fully until the
product stops fully.
B
2. Disengage the cutting deck. Refer to
and disengage the cutting deck on page 15 .
3. Put the throttle control in the slow position and let
the engine operate at idle speed for some
minutes.
4. Put the cutting deck in the transport position.
Refer to
position or mow position on page 13 .
5. Turn the ignition key to the "STOP" position and
remove the ignition key from the ignition.
B
WARNING: Always stop the product,
engage the parking brake and remove
the ignition key before you go away from
the product.
CAUTION: The exhaust gas from the
warm engine can cause burn damage to
the grass. To prevent burn damage , to
the grass, always stop the engine when
you stop the product on grass areas.
A
To set the cutting deck in transport
1717 - 001 - 10.09.2021
To engage