Husqvarna TS 148XK Manual Del Usuario página 23

To replace the battery
The battery is installed below the seat.
WARNING: Risk of electrical shock and
burn injuries. Do not use metal
wristbands or other metal accessories.
Metal items that touch the battery
terminals can cause burn injuries,
electrical shock, and short circuit of the
battery.
1. Stop the product. Refer to
page 14 .
2. Open the engine cover.
3. Remove the terminal covers (A).
A
4. Remove the bolt and the nut to disconnect the
black (negative) battery cable from the negative
(-) terminal.
WARNING: Risk of electrical shock
and burn injuries. The black
(negative) battery cable must be
disconnected before you disconnect
the red (positive) battery cable.
5. Remove the bolt and the nut to disconnect the
red (positive) battery cable from the positive (+)
terminal.
6. Carefully remove the battery from the product.
7. Install a new battery.
8. Connect the red (positive) battery cable to the
positive (+) terminal and tighten the bolt and the
nut.
WARNING: Risk of electrical shock
and burn injuries. The red (positive)
battery cable must be connected to
the positive (+) terminal before the
black (negative) battery cable is
connected to the negative (-) terminal
to prevent injury and accidental
grounding.
9. Connect the black (negative) battery cable to the
negative (-) terminal and tighten the bolt and the
nut.
10. Install the terminal covers.
11. Close the engine cover.
1717 - 001 - 10.09.2021
To stop the product on
To connect the jumper cables
WARNING: Risk of explosion because of
explosive gas that comes from the
battery. Do not connect the negative
terminal of the charged battery to or near
the negative terminal of the weak
battery.
CAUTION: Do not use the battery of
your product to start other vehicles.
1. Connect one end of the red battery cable to the
POSITIVE (+) battery terminal (A) on the weak
battery.
B
A
2. Connect the other end of the red battery cable to
the POSITIVE (+) battery terminal (B) on the
charged battery.
WARNING: Do not let the ends of the
red battery cable touch the chassis.
This will cause a short circuit.
3. Connect one end of the black battery cable to the
NEGATIVE (-) battery terminal (C) on the
charged battery.
4. Connect the other end of the black battery cable
to a CHASSIS GROUND (D), away from the fuel
tank and the battery.
To remove the jumper cables
Note: Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
C
D
23