Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Device elements
Before using the device, the operator must familia-
rise himself with all device features and the appli-
cable safety instructions.
Overview [fig. I]
1 Intake opening/cap with filter pad
2 Housing
3 clamping bracket
4 sleeve/repeat-action control
5 Release button
6 Follower
7 Exhaust gas opening
8 Trigger
9 Magazine
10 Magazine foot
11 fastening part stop
12 Belt hook
13 Battery
14 Battery release button
15 control display for battery charging state
16 Cover / intake slot for gas cartridge
Intended use
This device is intended to be used for driving
fasteners into concrete, full block calcium silicate,
full bricks and steel using the original Würth system
accessories.
Any other use is considered improper.
The user is responsible for damage resulting from
improper use.
. +49 1805-60 65 69 (14 cent/min).
Gas nailer technical data.
Item
Firing power (max.)
Fastener length x fastener
- Ø (max.)
Magazine capacity
Dimensions (height x length
x width)
Weight
Gas cartridge item no. 0864 900 400
Capacity
Substance
Hazard class
086494
1000/h
20 to 65 mm x
2.6 to 3.7 mm
40 pcs
467 x 122 x
450 mm
4.4 kg
80 ml
- Propylene
2.1 UN 1965
Max. ambient temperature 50°C
Energy reserve
Mains adapter
Input voltage / current
Output voltage / current
Charger
Input voltage / current
Output voltage / current
Charging time
- Discharging the battery
- first use
Battery
Nominal voltage
Capacity
Ambient temperature
Energy reserve with fully
charged battery
Method of functioning
The device has a combustion drive with explosive
gas mix. By ignition of the gas mix, the piston is
actuated and drives in the fastener. Exhaust gas and
noise emissions, which may be hazardous to health,
are generated during the combustion process.
Adhere to the stipulated safety instructions.
Due to its design, this device is not classified as a
powder-actuated tool. It is recommended to observe
fundamental German trade association provisions
(BGV A).
Battery and charger (fig. II)
Charge the battery
The battery must be charged for 24 hours prior to
first use and when it has not been in use for a longer
period of time to achieve full capacity.
To remove the battery from the device, fully
■
push the two release buttons 14.
Plug the power plug into the socket and the
■
charging plug into the socket of the charger.
3 The charging process starts as soon as the
battery is set in the charging cradle. The battery
warms up during charging. This is a normal
process.
approx. 1100
firing processes
100–
240 V AC / 0.4 A
12 V/ 1.2 A
12V/1.2 A
10 V/ 0.8 A
120 min
24 h
NiMH
6 V DC
1.5 Ah
5 - 50 °C
approx. 3000
firing processes
33
Tabla de contenido
