Alternative Installation Methods; Electrical Connection From Above On Unfinished Walls; Electrical Connection From Below On Unfinished Walls; Electrical Connection On Unfinished Walls With Short - Stiebel Eltron DCE-C 6/8 Trend Operación E Instalación

iNSTallaTiON

alternative installation methods

12. Alternative installation methods
WARNING Electrocution
Before performing any work on the appliance, discon-
nect all poles from the power supply.
12.1 Electrical connection from above on unfinished
walls
1 Cable grommet
2 Cable routing
f Break out the required aperture in the back panel for the f
power cable (for positions, see chapter "Specification / Di-
mensions and connections"). Deburr any sharp edges with a
file.
f Cut a hole in the cable grommet to fit the selected connecting f
cable. Fit the cable grommet.
f Reposition the mains terminal from the bottom to the top. f
To do so, unclip the mains terminal by pushing it firmly to
the left and pulling it forwards. Turn the mains terminal with
connecting cables 180° clockwise. Lay the internal wiring
under the cable guide. Clip the mains terminal in by pushing
it inwards and to the left until it clicks into place.
f Install the appliance and connect the power cable to the f
mains terminal as described in chapter "Installation / Stand-
ard installation on finished walls".
12.2 Electrical connection from below on unfinished
walls
1 Cable grommet
www.stiebel-eltron.com
f Break out the required aperture in the back panel for the f
power cable (for positions, see chapter "Specification / Di-
mensions and connections"). Deburr any sharp edges with a
file.
f Cut a hole in the cable grommet to fit the selected connecting f
cable. Fit the cable grommet.
f Install the appliance and connect the power cable to the f
mains terminal as described in chapter "Installation / Stand-
ard installation on finished walls".
1 12.3 Electrical connection on unfinished walls with
If the power cable is not quite long enough, you can install the
mains terminal in the appliance a little closer to the aperture.
2
1 Cable grommet
f Reposition the mains terminal from the top to the bottom. To f
do so, unclip the mains terminal by pushing it firmly to the
left and pulling it forwards. Clip the mains terminal in at the
bottom by pushing it inwards and to the left until it clicks
into place.
12.4 Electrical connection from the side on finished
f Cut and break out the required aperture in the appliance f
back panel and appliance cover for the power cable (for po-
sitions, see chapter "Specification / Dimensions and connec-
tions"). Deburr any sharp edges with a file.
f Install the appliance and connect the power cable to the f
mains terminal as described in chapter "Installation / Stand-
ard installation on finished walls".
1
short power cable
walls
1
DCE-C Trend | 9