Additional Building Instructions Continued - THINK GIZMOS TG902 Manual De Instrucciones

1. PAGE HEADER

3.3 Additional Building Instructions Continued

Page 18:
Tips:
1. Place the clock on a flat level surface.
2. If the pendulum swings too fast or too slow, tighten or loosen the regulating screw to
adjust speed.
1. The bottom of shim on the horizontal line is original position.
2. Speed up: Tighten the screw.
3. Slow down: Loosen the screw.
3. When the timer doesn't work.
1. Q: The escapement wheel of the pendulum doesn't spin after wound up and pulled
(refer to Step 4 on page 17).
A: Gears don't produce energy to drive escapement wheel. Please check if gears
hinder each other.
2. Q: When countdown is over, the pendulum still swings.
A: The spring is too tighten. The pendulum will stop after a while.
3. Q: The pendulum stops during a countdown.
A: Check if gears hinder each other, or spring needs to be wound up again.
4. How to change battery.
1. Refer to Step 15 and Step 14 on page 16. Disassemble the dial first and then
replace battery.
Please observe the building instructions carefully. If you have misplaced the Building
Instructions they can be downloaded at the below link.
https://bit.ly/3tq7vTG
7 7