Additional Building Instructions - THINK GIZMOS TG902 Manual De Instrucciones

1. PAGE HEADER

3.2 Additional Building Instructions

Page 5:
Pay attention to the direction of gear teeth. Avoid direction error.
Page 6:
T2 is only used on this step. Don't mix it up with T1.
Page 10:
Same Direction
Page 16:
a.Assemble the hour hand and minute hand at 9 o'clock as shown in the picture. Once
placed use the time setting dial to set local time. Do not disassemble the clock hands after
assembly to avoid any damage.
b. Time Setting Dial.
c. Load Battery, Unload Battery.
Page 17:
a. Timer Bell
b. Bell Key
c. Escape Wheel
d. Pallet Fork
e. Timer Pointer (range 0-30mins)
f. Porch Hook
g. Timer Key
h. Timer Pendulum
Timing Instructons:
1. Rotating timer pointer counterclockwise, can be set for a maximum of 30 Minutes (fully
round one circle). If it is hard to revolve because of insufficient waxing, pull up the timer bell
a little bit and release porch hook.
2. Rotate timer key clockwise to finish winding. (A little hard twist means it's done.)
3. Rotate bell key clockwise to finish winding. (A little hard twist means it's done.)
4. Pull timer pendulum slightly to activate the countdown. The bell rings when time is up.
5. Start a new countdown: Repeat from step 2 to step 5 and set the timer pointer to the
correct place. (Skip step 2 if time key still still rotates and time pendulum is still working.)
Note:
1. Wax parts properly as required.
2. Pendulum only swings during a countdown. The clock on the other side shows time.
3. Avoid over winding, otherwise the spring will malfunc tioned or be destroyed.
6 6