ECOFOREST Vigo Manual De Instalación Y Mantenimiento página 36


Stainless steel hose clamp.

T of 135° with outlet.

Elbow of 45°.

Wooden ground.

Non flammable floor protection.

Stainless steel flexible tube.

Rigid flexible pole adapter.

Anti blow-back seal.

Minimum 200mm.

It must exceed roof height by 1 metre.
If the tube over 4 m in length, the next larger

size will be used.
When installing a flexible tube for gas outlet, be careful that this is not in contact or close to the circuit board
or combustible material.
KEYBOARD CONECTION, POWER WIRING AND ROOM THERMOSTAT.
The first thing to do is locate the keyboard in the fireplace inside a box mounted with bracket (
remote control, room thermostat and power wiring, and cleaning brush.
We must adjust the screws that secure the bracket to the stove (
keyboard connection band (

back of the keyboard ( ). Connection has only one position.
Cíes stove has a hole on the left side (facing the stove from the front) where the keyboard must be inserted.
If for convenience or necessity of the installation, it is required a keyboard support, we have one as an option.
The Paris stove model is delivered with the keyboard mounted on the top of the stove.
The room sensor (
that corresponds to the Vigo model. You will know the stove recognize that because the room temperature it will be
Shown in the control panel. If you connect a thermostat or contact instead of displaying the room temperature it will
be shown ( · ) indicating this that there is something connected in the communication port.
IF YOU HAVE ANY DOUBT ABOUT THE CONNECTION, THE INSTALLATION PRACTICABILITY OR THE USE OF
SUCH DEVICES, CONTACT YOUR DISTRIBUTOR WHO WILL INFORM YOU.
A BAD USE OR SETTING OF THESE DEVICES MAY CAUSE A MALFUNCTION OR EARLY DEGRADATION OF THE
STOVE.

Screws for keyboard support.

Support with mounted keyboard.

Keyboard's connection band and C.P.U.

Back side of keyboard.

Thermostat connection.

Power connection ~230/240V - 50Hz.

Thermostat.

), Which is situated at the back side attached with adhesive tape and connect it to the

) and the power wire are connected at the rear of the stove as Shown in the diagram

) as shown in drawing 9. Connect the
35
Drawing 8

), with the
Drawing 9