When Taking A Break; Maintenance; Every Day - Chicago Pneumatic CP 1210 Instrucciones De Seguridad Y De Funcionamiento

Martillos neumáticos manuales
Ocultar thumbs Ver también para CP 1210:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 68
CP 1210, CP 1230, CP 1240

When taking a break

During all breaks you must place the machine in
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
In the event of a longer break or when leaving the
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.

Maintenance

Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
Before starting maintenance on the machine,
clean it in order to avoid exposure to hazard
substances. See "Dust and fume hazards"
Use only authorised parts. Any damage or
malfunction caused by the use of unauthorised
parts is not covered by warranty or product
liability.
When cleaning mechanical parts with solvent,
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
For major service to the machine, contact your
nearest authorised workshop.
After each service, check that the machine's
vibration level is normal. If not, contact your
nearest authorised workshop.

Every day

Before undertaking any maintenance or changing
the insertion tool on pneumatic machines, always
switch off the air supply and bleed the machine by
depressing the start and stop device. Then
disconnect the air hose from the machine.
Clean and inspect the machine and its functions
each day before the work commences.
Check the tool retainer for wear and function.
Conduct a general inspection for leaks and
damage.
Check that the air inlet nipple is tightened and
that the claw coupling is free from damage.
9800 0608 90d | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and operating instructions
For the machine to maintain the specified
vibration values, always check the following:
Too big a clearance between the insertion tool´s
shank and the chisel bushing will generate
increased vibrations. To avoid getting exposed to
excessive vibrations, check the chisel bushing for
wear. Use the guage that corresponds to the
insertion tool´s shank dimension.
If it is possible to push the guage (point A) fully
into the chisel bushing (to point B), then the
bushing or fronthead should immediately be
replaced. See also "Checking for wear on the tool
shank" for checking the insertion tool´s shank.
If the machine is equipped with vibration-reducing
handles their function should be checked.
Check that the handles are moving freely
(up-down) and never jam.
Check that the springs are not damaged, see
"Vibration reducing handles main parts".
Change damaged parts immediately.
Replace worn components in good time.
Make sure that all the attached and related
equipment, such as hoses, water separators and
oilers are properly maintained.
17
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Cp 1230Cp 1240

Tabla de contenido