Bradley EFX 125 Manual Del Usuario página 7

Installation
Troubleshooting: Piston Disassembly and Cleaning
To prevent injuries, use proper protective equipment for
eyes and skin when using a propane torch.
Remove the valve's top cap and pull out the
A
push rod and then the thermostat. You may use a
needle-nose pliers to remove the thermostat from
the valve body if desired.
B Insert a 7/16" dia. rod into the valve and into the
piston overheat chamber. Mark the length of the
rod inside the valve. Push the rod until the piston
stops and mark the new length.
If the rod travels less than1/2", the piston is not
moving freely within the liner and they must be
cleaned:
1. Remove the control section assembly, top cap
and thermostat.
C
2. Unthread the liner from the cap (it is glued
together; the o-rings must be removed and heat
should be applied to melt the glue and loosen
the liner).
3. Clean the piston and liner with any cleaner
suitable for brass and stainless steel (400-grit
sandpaper may be used to polish and hone the
piston and liner).
Push the mechanism up and down several times
to make sure the piston moves smoothly and
D
consistently. If it is not consistent, repeat Procedure
C until it moves freely, or replace. Contact your
Bradley representative and ask for Piston/Liner Kit
(part number S65-288).
Bradley • 215-1594 Rev. C; EN 10-09-010
EFX 125/S19-2300
Top Cap with
Push Rod
Thermostat
The second mark
should be 1/2"
7/16"
higher on the rod
Rod
than the first mark.
Piston Overheat
10/15/2012
Chamber
7