Technical Data; General Safety Advice For Electrical Power Tools; Workplace Safety - Parkside PABS 12 A1 Instrucciones De Utilización Y De Seguridad

Technical Data

Cordless Drill PABS 12 A1:
Nominal voltage: 12 V
Idle-running speed: 1st gear: 0–400 min
2nd gear: 0–1300 min
Drill chuck
clamping range: max. 10 mm
Maximum
drill diameter:
Steel: 8 mm
Wood: 20 mm
Battery pack PABS 12 A1-1:
Type: LITHIUM-ION
Nom. voltage: 12 V
Capacity: 1300 mAh
PABS 12 A1-2 Fast Charger:
INPUT
Nominal voltage: 230 V∼ 50 Hz
Nominal power: 27 W
OUTPUT
Nominal voltage: 12.6 V
Charging current 1500 mA
Charging time: approx. 60 min
Protection class: II /
Noise / vibration data:
Measured values for noise are determined in accord-
ance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level: 67.2 dB(A)
Sound power level: 78.2 dB(A)
Uncertainty K: 3 dB
Wear ear protection!
Total vibration (vector sum of three directions) is
calculated in accordance with EN 60745:
Drilling in metal: Vibration emission value
a
uncertainty K = 1.5 m / s
Introduction / General safety advice for electrical power tools
-1
-1
= 1.507 m / s ,
2
h,D
2
Screwing:
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
exceed the value specified in these instructions. Re-
gularly using the electric tool in such a way may
make it easy to underestimate the vibration.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
General safety advice for
electrical power tools
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
The term "electrical tool" used in the safety advice
refers to electrical tools powered by mains electrici­
ty (by means of a mains lead) and electrical tools
powered by rechargeable batteries (without a
mains lead).

1. Workplace safety

a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
,
can lead to accidents.
Vibration emission value
a = 0.747 m / s ,
2
h
uncertainty K = 1.5 m / s
The vibration level specified in
Read all the safety advice
GB/MT
.
2
37