Safety Instructions; Warnings For Gas And Electric Installation - Fulgor Milano Sofia Manual De Uso Y Cuidado

Rangetop gas 30”- 36”
Ocultar thumbs Ver también para Sofia:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

2 - Safety Instructions

EN
WARNING
• For proper lighting and performance of the burners, keep
the igniters clean and dry.
• In the event that a burner goes out and gas escapes, open
a window or a door. Wait at least 5 minutes before using
the cooktop.
• Do not obstruct the flow of combustion and ventilation air.
• Do not use aluminium foil to line any part of the cooktop.
• If the rangetop cookers is near a window, be certain blow
over or near the burners; they could catch on fire.

Warnings for Gas and Electric Installation

In case of Propane gas installation
The appliance is produced ready for use with natural gas.
It may be converted for use with propane gas using the
propane conversion kit supplied with the appliance.
Be sure the unit being installed is correct for the type of gas being
used. Refer to the rating plate (see Installation Instructions).
WARNING
Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
CAUTION
• Always disconnect the electrical plug from the wall
receptacle before servicing this unit.
• For personal safety, this appliance must be properly
grounded.
• Do not under any circumstances cut or remove the third
(ground) prong from the power cord plug..
CAUTION
When connecting the unit to propane gas, make certain
the propane tank is equipped with its own high pressure
regulator. In addition, the pressure regulator supplied with
the appliance must be on the inlet gas pipe of this unit.
In case of electrical failure
If for any reason a gas control knob is turned ON and there is
no electric power to operate the electronic igniter of the cook
top, turn OFF all gas control knobs and wait 5 minutes for the
gas to dissipate before lighting the burner manually.
To light the burner manually, carefully hold a lighted match to
the burner ports and push and turn the gas control knob to HI
until it lights and then turn the knob to desired setting.
4
Tabla de contenido
loading

Tabla de contenido