Taking Care Of The Guide Bar; Shroud - Stihl MS 362 C-MQ Manual De Instrucciones

English

Taking Care of the Guide Bar

2
1
Turn the guide bar over – every time
N
you sharpen the chain and every
time you replace the chain – this
helps avoid one-sided wear,
especially at the nose and
underside of the bar.
Regularly clean the oil inlet hole (1),
N
the oilway (2) and the bar groove
(3).
Measure the groove depth – with the
N
scale on the filing gauge (special
accessory) – in the area used most
for cutting.
40
Chain Chain pitch
type
Picco 1/4" P
Rapid 1/4"
Picco 3/8" P
Rapid 3/8"; 0.325"
Rapid 0.404"
If groove depth is less than specified:
Replace the guide bar.
N
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
3
Minimum

Shroud

groove depth
0.16" (4.0 mm)
0.16" (4.0 mm)
Removing the Shroud
0.20" (5.0 mm)
0.24" (6.0 mm)
To switch off the engine, move the
N
0.28" (7.0 mm)
Master Control lever in the direction
of STOP or † – when released, the
Master Control lever springs back to
the run position F.
Push the hand guard forward – the
N
chain is locked.
Open the twist locks (1) by turning
N
them 1/4 turn counterclockwise with
the combination wrench.
Remove the shroud (2).
N
Installing the Shroud
Place the shroud in position.
N
Close the twist locks by turning
N
them a 1/4 turn clockwise.
1
2
1
1
MS 362 C-MQ