Engines; Emission Control Systems Warranty; Emission Control System Warranty Statement; General Warranty Provisions - Scania DC13 XPI Manual Del Operador

Scania engines engine war-
ranty for industrial engines
Emission control systems
warranty
IMPORTANT!
Only applicable to engines used in the U.S.A.
Table of Contents
General warranty provisions
Warranty period
Parts covered by the Warranty
General warranty limitations
Specific warranty exclusions
Customer support
Emission control system war-
ranty statement

General warranty provisions

The emission control systems of your new Scan-
ia Engines ("Scania") industrial diesel engine
were designed, built and tested using genuine
parts, and were certified as being in conformity
with federal emission control regulations. Scania
warrants to the original owner, and to each sub-
sequent owner, of a new Scania industrial diesel
engine ("You") that the engine:
1.
Was designed, built and equipped so as to
conform at the time of sale with all applica-
ble regulations under Section 213 of the
Clean Air Act, 42 U.S.C. § 7547, for their
full useful life and designed, built and
equipped so as to conform with all applicable
regulations adopted by the California Air Re-
sources Board pursuant to its authority under
Chapters 1 and 2, Part 5, Division 26 of the
California Health and Safety Code, and;
2.
Is free from defects in material and work-
manship which would cause such engine to
fail to conform to applicable regulations for
its warranty period or otherwise cause the
failure of a warranted part to be identical in
all material respects to the part as described
OPM 200 es-ES
Scania engines engine warranty for industrial engines
in the engine manufacturer's application for
certification.
Where a warrantable condition exists, Scania
will repair your heavy-duty off-road engine at no
cost to You including diagnosis, parts, and labor.

Warranty period

This warranty shall apply for one of the follow-
ing periods, whichever occurs first:
• 3,000 hours of operation as determined by a
device to measure hours of use, or
• Five years
4
4
Each engine is equipped with a device to meas-
5
ure hours of use. If that device fails to account for
hours of use due to defects in materials or work-
6
manship, the engine shall be warranted for a pe-
7
riod of five years. The warranty period shall
7
begin on the date the engine is delivered to the
first ultimate purchaser who, in good faith, pur-
chases the engine for purposes other than immi-
nent resale.
The Warranty on emission-related
parts shall be interpreted as follows:
1.
Any warranted part which is not scheduled
for replacement as required maintenance in
Scania's written instructions for maintenance
and use of the engine by owner shall be war-
ranted for the warranty period defined above.
If any such part fails during the period of
warranty coverage, it shall be repaired or re-
placed by the engine manufacturer according
to Subsection (4) below. Any such part re-
paired or replaced under the Warranty shall
be warranted for the remaining warranty pe-
riod.
2.
Any warranted part which is scheduled only
for regular inspection in Scania's written in-
structions for maintenance and use of the en-
gine by owner shall be warranted for the
warranty period defined above. A statement
in such written instructions to the effect of
"repair or replace as necessary" shall not re-
duce the period of warranty coverage. Any
such part repaired or replaced under warran-
ty shall be warranted for the remaining war-
ranty period.
4
©
Scania CV AB 2020, Sweden