Environmental Protection; Technical Specifications - Metabo W 2000 Manual Original

C Raised support flange
D Diamond discs (always use with safety guard or
parting safety guard attached)
E Clamping nut (8)
F 2-hole spanner
G Roughing disc (always use with safety guard
attached)
H Louver disc (always use with safety guard
attached)
I Parting disc (always use with parting safety
guard attached)
J Parting safety guard with guide slot (place on
machine and secure with screws.) (with adapter
for connection to a suitable dust extractor for
extraction of stone dust generated when cutting
stone slabs.)
K Hand guard (for attaching under the additional
side-mounted handle.)
L Supporting disc for fibre discs (always attach
using the supporting disc clamping nut
supplied.) (always use with the hand guard
attached.)
M Fibre discs (always use with the hand guard
attached.)
N Steel wire brushes (always use with the hand
guard attached.)
O Bench cut-off stand
For complete range of accessories, see
www.metabo.com or refer to the main catalogue.
12. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
If the mains connection cable of this tool is
damaged, in order to prevent endangering
personnel and property it must be replaced by the
manufacturer, or the Customer Service of the
manufacturer, or a similarly qualified person.
Any Metabo power tool in need of repair can be sent
to one of the addresses listed in the spare parts list.
Please enclose a description of the fault to the
power tool.

13. Environmental Protection

The sanding dust generated may contain
hazardous materials: do not dispose of with the
household waste, but at a special collection point
for hazardous waste.
Metabo packaging is 100% recycled. Scrap power
tools and accessories contain large amounts of
valuable resources and plastics that can be
recycled.
These instructions are printed on chlorine-free
bleached paper.

14. Technical Specifications

Explanation of details on page 3. Subject to
changes serving technical progress.
D = Maximum sanding disc diameter
max
t = max. permitted thickness of clamping
max,1
shank on accessory when using clamping
nut (8)
t = Roughing disc/Parting disc:
max,3
max. permitted thickness of accessory
M = Spindle thread
l = Length of the grinding spindle
n = No-load speed (maximum speed)
I = Current at 120 V
120 V
HP = Horse power
m = Weight without mains cable
Wear ear protectors!
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
ENGLISH en
11